Skip to content

WATERPROOFING PENTENS T-100 PU BITUMENT

Juni 9, 2014

Description
PENTENS T-100 is a single component which is newly developed polymer of MMA, natural rubber, and polyurethane combines with the reaction with asphalt and then being modified and further emulsified to form elastic waterproof membrane.

Uses
To provide a better water and vapourproof in complicating application surface compare to membrane-type and ensure better integrity between applied surfaces and waterproofing coating. Areas of application include:
– Floor slabs
– Suspended floors
– Terraces and balconies
– Patios
– Bathrooms
– RC gutters and planter boxes
– Swimming pools
– Water tanks
– Basements and fountains
– Retaining walls

Advantages
– Ease of application directly from container.
– High elasticity.
– Superb adhesive strength.
– Can apply directly on damp or wet surfaces.
– The softening point will not be further softened due.
– To hot and humid climate in tropical countries.
– Resistant to any bubbling or side osmosis
– Phenomenon even submerge in water for a long time.
– Capable of re-application.
– Non-toxic.


Technical & Physical Data

Foam

Liquid

Colour

Black Coffee

Density

1.08

Hardness (Hs)

35

Tensile Strength

20.9 kgf/cm2

Elongation at break

793%

Tensile Strength at 100% Elongation

3.5kg/cm2

Tear Strength

11kgf/cm2

100% Modulus of Elasticity

5.5kgf/cm2

Water Vapour Transmission of Materials

6.165 grains/ft2 x h x in x Hg

Puncture

1.6kgf

Chemical Resistance

No Changes on the surface of the sample

Shelf Life

1 year when unopened and undamaged

Storage Condition

Store in a dry cool place

Packaging

20kg/pail, 200kg/drum

 

Important Notes
1. Minimum ambient and substrate temperature is 5°C.
2. Never apply more than 3 kg/m2 of PENTENS T-100 in one single layer.
3. Apply only to clean, sound substrates where surfaces should be well dampened
    but free of surface water and leaks.

Instruction For Use
Surface Preparation
All the surfaces must be clean, free from grease, oil, laitance, and remove all the dirt and contaminants, which might affect adhesion. The impurity outside the structure body should be cleaned thoroughly.
Any crack or water leakage area should be pre-treated and reinforced with PENTENS Repair System (for more detail, please refer to our Technical Department) before the waterproofing.
For some difficult areas, such as the position of cracks, secondary joint, right angle of wall and the boundary of water jacket shall be strengthened first with one layer of PENTENS T-100.
Priming
Dilute 1 portion of PENTENS T-007 permeable primer with 3 portion of clean water and then plaster directly to the surface to be waterproofed, in order to improved the bonding.
Application
With brush, roller or spray method apply the first coat of PENTENS T-100 on the application surface, leave to cure for approximately 8 hours before applying second coat.

Coverage
– Waterproofing roof, bathrooms and kitchen: 1kg/m2/mm per coat
– Waterproofing planter boxes, balconies, swimming pool and basements: 1.5kg/m2

Note
1. PENTENS T-100 should be applied in minimum 2 coats.
2. Primer is required in areas of extremely high infiltration for better bonding.

Curing
For optimum performance, PENTENS T-100 should be allowed to cure for 12 hours before the finishing concrete, tiles etc and during this time precautions must be taken in order to prevent damaging to the coating.

Cleaning
Tools and equipment just can be clean with clean water immediately after use.

Safety
Impervious gloves and barrier cream should be used when handling these products. Eye protection should be worn. In case of contact with eyes, wash thoroughly with plenty of water and seek medical advice if symptoms persist. If contact with skin occurs, it must be removed before curing takes place. Wash off with an industrial skin clearer followed by plenty of soap and water. Do not use solvent. Ensure adequate ventilation when using these products.

No comments yet

Tinggalkan Balasan

Isikan data di bawah atau klik salah satu ikon untuk log in:

Logo WordPress.com

You are commenting using your WordPress.com account. Logout / Ubah )

Gambar Twitter

You are commenting using your Twitter account. Logout / Ubah )

Foto Facebook

You are commenting using your Facebook account. Logout / Ubah )

Foto Google+

You are commenting using your Google+ account. Logout / Ubah )

Connecting to %s

%d blogger menyukai ini: